This week not much to do and not much done: I've finished the assembly all basic structures, I had to use my dremel on the rear 3D printed arms mount for a perfect fitting and I did a (aborted) experiment with a full set of DT02 arms. I'm doing a list of all the parts needed to complete suspensions so I will be ready for the next shopping session.
Arms in place... hope for ORB printed set.
RC Schrauben stainless steel screws, not a good choice.
Front...
... back with wing holders in place: shiny!
A bit of dremeling.
Nessun commento:
Posta un commento